Hi,
I have just set a security gateway and paired it with my View Manager.
So far so good.
When I connect thru the client, I can go up to selecting the type of machine I want to use, then the client opens up wide and after a while, it shuts down saying that the connexion to the remote computer has ended !
I suspect there is something to do with the fact that I didn't change anything at all in my View Configuration / Servers / View Connection Servers parameters but since I don't have a test environment, I'd rather be cautious before doing anything stupid. 
I went thru the documentation, but unfortunatelly, it is far from being obvious.
So if someone could give me a little hand 
I didn't checked any of the 2 boxes for Https Secure tunnel and PCoIP Secure Gateway. I guess (hope !) this is why I can't finalize the connection.
My question is what do I put in these 2 fields ?
Should I just tick them both and that's it ?
Should I tick them both plus replace what's in there with config lines from the security gateway ?
Should I configure soemthing somewhere else ?
My concerne is to activate the secure tunnelling from the manager (as I did y ignorance in the past) for my internal clients and then dropping all the connections while doing some maintenance on the View Manager !
And again, to me, the documentation is not very clear with that.
Many thanks.