Hello all,
After much deliberation, I upgraded from Fusion 3 to 4. One of the reasons for that is that unlike Parallels, Fusion 3 would remember that I run my Fusion window in full screen on my external secondary display. Thus, whenever I sit down at my desk and plug in the other monitor, Fusion would know to put my fusion window in it.
Sadly, after upgrading to Fusion 4, this is no longer the case. If I drag the Fusion window up to my second display and then set it to full screen, it fills my second monitor beautifully, and allows me to use my laptop display for other programs, etc. So far so good. Then, when I unplug the display from my MBP, Fusion switches to be running full screen on my MBP. So far so good, this is all just like Fusion 3.
The problem arises when I plug the external monitor in again. It registers and everything, but the Fusion 4 window remains running full screen on my MBP, and the second display just shows my desktop. In order to get Fusion back on my secondary display, I have to minimize it, drag it up to my external display, and reset it to full screen. As soon as I unplug, I have to go through the whole thing again.
How to I get it back to functioning like version 3 did?
Thanks, in advance!